Below is a description for the maps in this directory:



The maps are classified for Kawasaki V-Twin (all models), Yamaha Grizzly/Rhino 660 models, 

King Quad 700 and Arctic Cat 700 models.



For each model, there are three different combinations:

1) OEM-87 octane.  This map is very similar to what was loaded when your CDI left our facility. 

	Map #1 is loaded with a clone of the OEM Ignitor, all limiters enabled.

	Map #2 is optimized for 87 octane, with all limiters disabled.



2) OEM-91 octane.

	Map #1 is loaded with a clone of the OEM Ignitor, all limiters enabled.

	Map #2 is optimized for 91 octane, with all limiters disabled.



3) 87-91 octane.

	Map #1 is optimized for 87 octane, with all limiters disabled.

	Map #2 is optimized for 91 octane, with all limiters disabled.



*** EFI Pipe Maps are matched to the particular firmware version.  For example, the Rev 4.3 pipe

	map is ONLY for the Rev 4.3 firmware.  



Click on the desired map(s), and save to a location on your computer.  Open the USB Application,

and go to the "FILE" menu, and select "OPEN".  Browse for the desired file.  Then do a "MAP",

"WRITE TO POD" to save the file to the interface.



M109R maps are to be used when using the updated Suzuki fuel injector, Suzuki SKU 15710-48G00.



Extra Fuel Maps.  Labeled based on the extra amount of fuel applied (+5%,+10%).

- I.E. Muzzy (slip on)/power tip: 5%, Full Muzzy / HMF Swamp series 10%





Changes:

20150709 Rev6.3

- Changes to 2014+ KQ750 Map



20130801 Rev6.3

- Revision changed to match firmware.



20130701 Rev6.2

- Changed acceleration enrichment cycles to work with new firmware.



20121205 Rev6.1

- Revision changed to match firmware.



20121205 Rev6.0

- MAP cal was replaced with Afterstart Cycle Hold for compatibility with the new Live Tuner capable firmware.



20120727 Rev5.5

- Increased lean table values to deal with backfiring off hard throttle.



20110011 Rev5.5

- Changed Afterstart Cycle Hold to prevent engine from starting until the entered number of rotations occur.

	Used for machines that tend to be hard (rich) starting.  NOTE:  Map number just changed from 5.4 to 5.5 to match firmware.



20100330 Rev5.4

- Changed the afterstart cycles to match 1.5 firmware.

- Added 5% and 10% extra fuel maps for power tips, muzzy exhaust, etc.